Content from Saws on Skates may not be reproduced or used in any way whatsoever without the reveal written permission of the author. Quick excerpts and one photo might be used supplied full and clear credit is given to Saws on Skates with suitable links to the initial content. Saws on Skates is a signed up trademark.
We may get a commission when you utilize our affiliate links. Nevertheless, this does not affect our recommendations. 1. Moving Wall-O-Tools By Sue Brunclik I built this 8-ft.-long shelf system to take advantage of the narrow area in the corner of my garage. When the unit is "closed," I've got ready access to the tools holding on both doors.
I got everything I needed to develop this unit at a home center. The secret was to install the pegboard doors a minimum of 5 in. apart, so I might pack the back entrance with tools and still have it pass behind the front door. I purchased 2 96-in. Overhead Bypass Door Sets so each door might move by itself track.
I installed the shelves first, leaving adequate room underneath to store my mower and other garage fundamentals. All three shelves originated from a single sheet of plywood. The upper shelves are 11 in. large and the bottom one is 20 in. Reference used 11-in. doublemount brackets for the upper racks and 14-in.
I installed the sliding-door tracks on a 210 header that I anchored straight above the wide shelf with lengths of slotted angle extending from both the ceiling and wall (upper right image). To make the moving doors, I cut a single sheet of pegboard in half and framed both pieces with 12 stock (each door has 4 vertical stiles for rigidness).
After installing the doors, I obstructed the open end of the tracks with a stop. The doors hang from commonly spaced tracks mounted on a 2 x10 header. Lengths of slotted angle hold the header safely in location. The doors slide efficiently on roller-equipped hangers. Each track has two grooves, so you can easily alter the spacing in between the doors and racks, if required.
0 
Star